Lithium battery setup for camper truck

New to renewable energy? Have questions? Here's a great place to ask them and view information about wind and solar power basics.

Re: Lithium battery setup for camper truck

Postby Tracker » Thu Sep 17, 2015 5:14 pm

davef wrote:A good suggestion. Gets around the hassle of trying to integrate an alternator into the system. .

and, the higher the voltage, the lower the current..
so if you were trying to get 12V from the engine to the trailer at say 200W, then that is a current of 16A
but at 24V the current is 8A, and so on, so the higher you could get the voltage, the easier it is for the cable..

So the best way would be to find out what the Solar-Charge-Controller limit is,201527_4_71_72_73_74_75,201409_3

this one puts out 56V but only 112W, so the line current would be just 2A, for a final charging current of more like 10A... there are likely bigger ones if one searches.. ;)

here's 192W..., = 13A battery charge for 48V line voltage and just 4A and about $30au,201527_4_71_72_73_74_75,201409_3
Retired Engineer and keen PV experimenter - Always ready to learn and share.
2 x CMS2000 (fan cooled) GCI and SE 170W panels
1.7kW First Solar/Outback Island circuit - Peak Replacement Power
Governments won't save the world :-) They will just TAX it :-(
Solar Crusader
Solar Crusader
Posts: 5113
Joined: Wed Sep 23, 2009 5:54 am
Location: SYDNEY --- EA - Network, Retailer - EA

Re: Lithium battery setup for camper truck

Postby Privatteer » Wed Sep 23, 2015 2:19 am

Most alternators put out about 14.4V.

Something like the morningstar relay driver might be a better option.
Use 1 input for fault input from a battery management system (if chosen)
Use 1 output for a high current relay from alternator supply.
Set it to monitor supply voltage.

At 14.4V, or 3.6V a cell disconnect the relay after x time. Therefore charging at whatever current the alternator throws out which should be well over some of the linked ebay options.
It can be set to reconnect after x time at x voltage. ie 10mins at 13.2V. There is also option to set minimum off time for the relay, so if you really wanted you could lock it out for 8 hours. All depends on how you want to manage it.

The 200w solar panel/reg should do the rest if programmed correctly and assuming the camper has no high loads while driving will maintain float for quite a while.

A standard dual battery relay/diode/switch depending on preferred option can then be used to protect the car battery from being discharged while stationary. Or if you picked up a accessory supply could be used to interlock with the relay in several methods to disconnect it once ignition off.

Stage 1:
Fronius Primo 5 + 6.6kW Canadian Solar
Solar Crusader
Solar Crusader
Posts: 476
Joined: Sat Nov 19, 2011 12:00 am
Location: South West WA


Return to Q&A - wind and solar power basics

Who is online

Users browsing this forum: No registered users and 2 guests

new solar power specials